How to Change the Map of Your No One Survived Server

No One Survived ships with two maps. Which one your server loads is controlled by the value OpenMap in the configuration file.

Value	Map
`Map01`	Large map (default), roughly 8 x 8 km
`Map02`	Small map, roughly 4 x 4 km – the original map of the game

Switch the map

Stop the server
Stop your server via the dashboard. The setting is only read on server start.
Connect via SFTP
Connect to your server via SFTP.
Open Game.ini
Open the following file:
```
/WRSH/Saved/Config/WindowsServer/Game.ini
```
Note
If the file does not exist yet, start the server once so it gets created. Stop it again afterwards.
The folder is called WindowsServer on your Linux server as well. That is intended – No One Survived only ships a Windows server application, which runs on Linux servers through a compatibility layer.
Enter the map
Enter the desired value in the [ServerSetting] section. If the line does not exist yet, add it:
```
[ServerSetting]
OpenMap=Map02
```
Set a new save name
Enter a new save name in the dashboard so a separate world gets created for the new map. Your previous savegame stays intact under its old name.

Note
Why a separate name?
An existing savegame was created on the map you started it on. If you assign a separate save name for the new map, you can switch back at any time by entering the old name again.
Start the server
Save the file and start your server. On startup the selected map is loaded.